Federal Freecoaster Hub

[broke_khe]

14mm axle ,  does this have removable axles? http://www.flatlandfuel.com/index.asp?PageAction=VIEWPROD&ProdID=988

Like, could i take off the 14mm axle and put a 3/8 axle on?


Designed in collaboration with KHE
-Same internals as KHE Reverse
-9T or 11T drivers
-Sealed Bearings
-LHD or RHD
-36h or 48h


-22oz/623g Will the sealed bearing hold out for a long time???

[PSchoolen]

if you want 3/8" then this is the one you will want:

http://www.flatlandfuel.com/index.asp?PageAction=VIEWPROD&ProdID=1151

[JUGGARNAUT]

I love mine ,Thanks Pat and Mike from FF!!!!

[broke_khe]

Jugger.. Do you jump off ledges and grind?

[JUGGARNAUT]

All the parts on that KHE just went on to my new Seshin Sh!thawk street frame,I trust them that much ,I do ride street as well on all my bikes,some are better suited than others .I do jumps and ledges but grinds would only effect the pegs and axles,not so much the hubs as they're mostly isolated due to the dropouts holding everything solid.I do alot of picks though ,eg;Toothpicks,Icepicks,nosepicks,,,,,so I'd say the parts i use are also street worthy as most are street part anyway. I've yet to try my Haro due to waitng on some key parts,Its rocking a Nankai..............