this is my third chimera frame and i thing that chimera frames are super ultra mega etc. Welds are ugly but stark, and for me welds are trivial thing. most important things in frame for me are: 1st weight/resistance, 2nd geometry, 3rd color ..... 436th welds.
Im not talking about the welds all Im saying is when you take out a NEW products from a box you should put its on with no proplems. With my frame I got from Zin I had to...
Remove paint from the euro bb.
Remove paint from the headtube.
Find the headset would not fit.
Find the rear trangle is warped from heat
Find that the distanstance between the dropouts is to wide due to welding
Make two wide washers (primo chain trensioners with the axle cut off) to put on the wheel to make the wheel fit and not bend in the rear trangle when I tighten the nuts up.
So did any of that happen to you maksymilian with any of your frames from Zin?
Im not bashing Im just asking